Chromex Powered Titanium Anode Rod Kit for Most 40- to 89-Gallon Water Heater Tanks with 1-Gallon Descaler/Flush Solution to Eliminate Sulfur Smell

Your water heater is silently corroding right now. A powered anode rod stops it for good. The Chromex Powered Titanium Anode Rod uses Impressed Current Cathodic Protection (ICCP), the same technology used to protect submarines and pipelines, to actively fight corrosion inside your water heater tank 24 hours a day. Unlike traditional sacrificial anode rods that dissolve over time and need replacing every 3 to 5 years, this powered anode rod never gets consumed. It sends a small, continuous electrical current through the water, which reverses the corrosion process entirely. The tank walls are actively protected rather than just sacrificed against. Install it once and protect your tank for its entire lifetime. This powered anode upgrade for residential water heaters in the 40- to 89-gallon range and with a dedicated, standard top anode port. It is not compatible with Bradford-White heaters or units where the anode is integrated into the hot water outlet. This service kit also includes a 1-gallon water heater flush and descale solution for a cleaning and deodorizing treatment during the same maintenance window. Verify fit and anode location before ordering. Follow your water heater manufacturer guidance and flush the tank thoroughly after any cleaning treatment.

Features

• Powered anode rod bundled with 1 gallon of descaler flush solution to fully service the tank in a single job; powered anode rod provides continuous electronic protection to prevent corrosion and odor without being consumed, while descaler solution removes scale and mineral buildup to improve system performance; NSF® Certified to NSF/ANSI/CAN 60 for drinking water treatment chemicals
• Powered titanium anode rod eliminates rotten egg and sulfur smell from hot water permanently; stops tank corrosion without dissolving or wearing out; is not consumed like sacrificial rods and is intended to provide long-term corrosion protection
• Designed for 40- to 89-gallon water heaters that use a standard top anode port; not for Bradford-White® or heaters that use a hot water outlet anode, verify anode location before ordering
• Works with major brands such as American®, AO Smith®, Ariston, Bosch®, GIANT, John Wood, Kenmore®, GWS, State®, Lochinvar®, Reliance®, Rheem®, Richmond™, Rinnai®, RUUD®, Stiebel Eltron®, Whirlpool®, U.S. Craftmaster®, and GE®
• Requires a nearby outlet; install with water off and tank depressurized, follow heater manufacturer safety steps
• Low power consumption, costs less than $1/month to run
• To use, turn off power or gas and water supply, shut off the cold inlet, and relieve pressure; open drain valve and fully drain the tank, remove the existing anode rod, pour gallon of descaler solution into the tank through the anode port, briefly open the cold water inlet for about 5 to 10 seconds to help distribute the solution, then close it, allow the solution to sit for about 1 hour to dissolve scale and sediment, open drain valve and flush the tank completely, then refill and drain again with fresh water until clear; install the powered anode rod, reconnect power, and resume normal operation

• No maintenance required after installation; comes with 30-year replacement warranty
• Includes solution, 6-ft. 2-prong non-polarized power cord and adapter, 2 sockets (1-1/8 in. remove, 1-3/8 in. install), PTFE thread seal tape, and instructions